Hello guys, I have a problem with pearpc control panel. I was using Pearpc 0.3.1. I decided to use Pearpc control panel for configuring the config file. When I was done, I saved the config file but it showed the following error: Run-time error '76': Path not found. At that time I was running windows xp pro with servicepack 3. I have 2.80 Ghz and 768 mb ram.
What should I do? If I have to run pearpc instead of pearpc control panel, how do I mount the iso? How do I start pearpc from the command prompt? How will I create a config file?
I was planing to run Darwin 7.0.1. I need help!
Unable to create a config file with pearpc control panel
Forum rules
Welcome to the PearPC Help section. When posting a support request, please include basic information such as the PearPC version that you are running, the version of the OS that you are running/want to run in PearPC, and any error messages that you might see. Also, to make life easier for those less accustomed to txt language, please write in full words. Thanks!
Welcome to the PearPC Help section. When posting a support request, please include basic information such as the PearPC version that you are running, the version of the OS that you are running/want to run in PearPC, and any error messages that you might see. Also, to make life easier for those less accustomed to txt language, please write in full words. Thanks!
2 posts
• Page 1 of 1
Unable to create a config file with pearpc control panel
by macrocks » Fri Jun 25, 2010 2:07 am
- macrocks
- New Member
- Posts: 7
- Joined: Fri Jun 25, 2010 1:55 am
Re: Unable to create a config file with pearpc control panel
by macrocks » Fri Jun 25, 2010 7:49 pm
I finally solved the problem.
- macrocks
- New Member
- Posts: 7
- Joined: Fri Jun 25, 2010 1:55 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest